Analysis: the normal operation method of the sealing machine

First: check and prepare before starting up

1. This machine adopts 220V single-phase AC power supply, equipped with a three-pin socket with grounding of the casing. Before use, check whether the voltage of the power supply is compounded. The wiring is

No, the bottom line is connected.

2. Adjust the height of the semi-automatic sealing machine according to the operator's work.

3. Check that the lubrication of each rotating part is good, and inject a proper amount of lubricating oil.

4. If the initial use or the interval of use is too long, the electric heating tube may be damp and the insulation resistance may decrease (normal), and the low temperature preheating should be carried out.

Heat for half an hour and then perform normal operation.

5. Adjust the height and front and rear position of the conveyor table according to the size and filling amount of the bag. Height adjustment should use a special special meniscus wrench to loosen the bridge gear

Nuts, tightened after adjustment; press the seal width to adjust the position of the seal width positioning frame.

Second: boot operation

1. Press the power switch first, then the indicator light inside the button is on.

2. Turn the speed control knob to adjust the conveyor belt to the desired running speed.

3. Press the temperature rise switch, the indicator light inside the button is on, then rotate the knob below the temperature controller to point the pointer to the desired temperature value. At this time, the temperature controller

When the green light is on, the hot head starts to heat up. When the temperature reaches the specified value, the green light turns off and the red light is on, and the sealing machine can start working.

4. Press the fan switch as needed (the thin layer material needs to be cooled), the indicator light inside the button is on, and the cooling fan is activated.

Third: stop operation

1. In order to extend the service life of the sealing tape, the temperature rise switch must be cut off before the machine is stopped (the button indicator light is off), the temperature of the ironing head is lowered, and the sealing tape is continued.

Run for a while.

2. After about half an hour, the fan switch and the power switch can be disconnected, and the whole machine stops. At this time, the indicator light in the button is off.

Previous: NONE！

Next: NONE！